How to put cable modem router into bridge mode?

http://192.168.0.1

2. When at login page enter as shown

Username: admin

Password: admin

3. From the top menu bar, click on Wireless and select Disabled, then click Apply

4. From the top menu, click on Basic

5. From the left side menu click on DHCP and select No for the DHCP server and click Apply

6. From the top menu, click on Advanced, check off Enabled for RG Pass Through and click Apply

7. Power down the Zoom router and connect the RF connector to the unit as well as a WIFI router to any one for the 4 Ethernet ports.

8. Power up the modem first and then power up the WiFi router

http://192.168.0.1

2. When at login page enter as shown

Username: admin

Password: admin

3. From the top menu bar, click on Wireless and select Disabled for Wireless, then click Apply

4. From the top menu, click on Status

5. From the left side menu click on Security

6. From the Security screen, change the Mode from Router to Bridge and then click Apply

7. Power down the Zoom unit and connect the RF connector to the unit as well as a WIFI router to any one for the 4 Ethernet ports.

8. Power up the modem first and then power up the WiFi router

http://192.168.0.1

2. When at login page enter as shown

Username: admin

Password: admin

3. From the top menu bar, click on Wireless and select Disabled for Wireless, then click Apply

4. From the top menu bar, click on Status

5. From the left side menu, click on Connection

6. On the Connection page, change the eRouter Provisioning Mode from eRoute_Dualmode to Bridge and click Apply

7. Power down the Zoom unit and reconnect the RF connector.

8. Connect WiFi router to any one of the 4 Ethernet Ports

9. Power up the modem first then power on the WiFi router

1. Bring up browser (i.e. Internet Explorer, Chrome, Firefox, Safari etc.) and in the address bar type the following address to log into the router, then press Enter

http://192.168.0.1

2. When at login page enter as shown

Username: admin

Password: admin

3. Click on the Wireless tab

4. Select Disabled for Wireless and click Apply

5. Click on the Router tab

6. From the left side menu, click on Basic

7. Under the Basic menu on left side click on WAN Settings

8. From the WAN Settings page, select Bridging (NAT Off) for the Operation Mode and click Apply

9. Power down the unit and then reconnect the RF connector and connect a WiFi router to any of the 4 Ethernet Ports

10. Power up the Zoom first and then power on the WiFi route