|
Please Note: This answer is for our older X3, X4, or X5 55xx series modems without an "A" in the serial number( i.e.: nnnn-nnnn-nn-nn-nnnn ) If you have the "A" version of the X3, X4, X5 modem ( i.e.: nnnn-nnn-nn-nnA-nnnn ) or model "56xx", Click Here |
You may want to print these instructions before proceeding
These instructions explain how to configure the Zoom X3/X4/X5 (55xx, non-A model versions) for 1483 Bridged LLC with Bridge mode enabled:
-
Access the Zoom modem’s web console by entering the address 10.0.0.2 in your web browser. The default User Name and Password are:
- User Name = admin
- Password = zoomadsl
Note: The default User Name and Password must be typed in lower case letters
The Basic Setup page appears. Make the following changes:
- VPI: 0 (or set to your provider's specific setting)
- VCI: 35 (or set to your provider's specific setting)
- Encapsulation: 1483 Bridge IP LLC
- Bridge: Enabled
Note: Make sure your VPI and VCI are set properly as per your Provider's specs.
- Click Save Changes, Write Settings to Flash and Reboot, and then Confirm.
- After the modem is rebooted, click the Advanced Setup icon.
- Click LAN Settings. The LAN Configuration page appears.
- Change the DHCP Server to Disabled.
- Click Save Changes, Write Settings to Flash and Reboot, and then Confirm.
Once this is done the modem will be in full bridge mode allowing you to configure your LAN side router or firewall with static IP's provided by your ISP or enable DHCP if your Provider supports this.
Comments
0 comments
Please sign in to leave a comment.